8M Chrome Car Rim Protector Guard Wheel Tyre Tire Trim Rims Strip For Up To 4 x 18 Inch Wheel

Product Specific Information

1. The gap along the wheel rim should be around 5mm wide (up to max 5mm). 
2. Rims with sharp edge, non-continuous edge or bad kerb rash are not suitable.
3. Rims that are flat (i.e. parallel to or flushed/almost flushed with the rim) are also not suitable even if the edge is not sharp but slightly rounded.
4. Certain rim paint factors may affected the stickiness (eg. rim processed with dull polish, frosted or spray paint treatment).
⚠️ Buy on trial & error basis as you'll only know after installing!

Watch this short video to quickly check if your rim edge is suitable or not. 

Other General Information

Q1: For products pasted with double-sided foam or acrylic tape, will it leave tape residue if I remove it? 
A1: Such products are typically purchased with the intention of pasting them on for good. 

But if you do need to remove the product, then unfortunately, it can leave behind tape residue as these tapes are meant to be strong in order to withstand tough environment and weather elements.

Q2: How can I remove the tape residue? 
A2: We suggest taking the time to slowly peel/scrape off the residue as much as possible as we would not know how cleaning agents may react with your car surfaces. 

Q3: Wet wipes are more convenient to use. Can I use them to clean the surface before pasting the product?
A3: Wet wipes can contain chemicals and/or alcohol that can corrode the product's print or cloud up certain plastic surfaces. It is better to stick with the good old cloth. 

Q4: The tape on the product is not very sticky. What can I do?
A4: Such situations can be due to several reasons. But the most common reasons are:

(1) The surface was not cleaned thoroughly before pasting. There could still be moisture/dust/grease/'waxy" layer on car interior plastic surfaces. 
(2) Not ideal installation conditions (eg: cold/wet days, damp/dusty environment etc.)

First, ensure that the spot is thoroughly cleaned, especially the 'waxy" layer on car interior plastic surfaces.

Then, you can get double-sided foam/acrylic tape designed for car/external use from most hardware stores and replace the tape on the product.

1. Follow this quick guide on how to install adhesive-type rim protectors.
2. Clean the surface of Installation areas to ensure that it's clean with no oil, grease, wax, dust, moisture etc.
3. Recommended to install on hot & sunny days as cold/wet weather is not conducive for curing adhesive or paint works. 
4. Do not drive, wet your wheels or wash your car for 1-2 days after installation. 
5. Suggestion: Using lighter or hot hair dryer to slightly heat the adhesive tape on the product can increase its stickiness.